Parts
1. Hand handle	2. Converter	3. Guide rod
4. Scale	5. Screw rod	6. Enclosure
7. Seat for inserted rod	8. Ball valve	9. Inserted rod
10. Transducer

Installation Procedures:
1. Drill a hole in the customer's pipe by method of torch cutting, with diameter slightly less than Φ100, no burr at the edges of the hole to make the measuring probe inserted through it freely.
2. Weld a matched short-duct (supplied by Kent) on the hole on the pipe by spot welding, the axes line of the short-duct is perpendicular 90o to the one of the pipe, as well as its extending line is through the circle center of cross-section of the pipe, then welding all-around.
For adjustable type
3. First install ball-valve (Q41F-16R-32R, ID100mm, supplied by customer), then install converter on the valve.
4. The inserted deep is 0.5D, measuring the length of the short duct and ball valve, adjusting screw rod to make the inserted deep is conformed with the specification.
5. Check all if it is good, open valve slowly and check the leakage (care of personnel safety).


Caution:
1. Flow direction must be conformed with the flow arrow on the meter body;
2. When weld the flange and pipe, the converter should not be installed on the pipe to avoid any damage of the converter.