| |
| Blade Electrode Maintenance and Cleaning |
| |
Because the surface of the electrode will be covered easily by the dirtiness to cause output signal drift and swing or even failure the meter measurement when it used in dirty fluid such as slurry and sewage. Use the mechanical blade made by a sliming steel shaft, and adopting mechanical seal between hollow electrodes to prevent the fluid measured from being leakage, then clean the dirty electrode, see figure below.
Open the cover of the electrode to rotate the blade along with the surface of the electrode to clean the dirtiness by manual. |
Meter should be bigger than DN80 with 316L electrode.
Parts:
| 1.
Meter pipe |
2.
Blade |
| 3. Electrode
surface |
4. Liner |
| 5. Isolating
gasket |
6. Washer |
| 7. Electrode
|
8. Nut |
| 9. Spring |
10. ＾O￣
ring |
| 11. Block |
|
|
 |
| |
|
